Luggage Rack and Steps pictures

Here are some pictures of the luggage rack while removed from the Travco, that will be reinstalled after I get all the primer sanded off (if that ever happens).





The side rails are made of aluminum, the middle ribs are made of stainless steel c-channel and the end rods are made of chromed steel. It was attached with 8 screws with a synthetic rubber gasket between it and the roof. Each rib has a rubber strip on the bottom to prevent damage to the roof. The side rails are are 87.5" long and 51.5" wide and about 4" tall (outside dims.). Usable space is 6' long by 47.25" wide (inside dims). I removed it when I got it from the PO as only 3 screws held it down, the others had no grip and were allowing water to enter.

The pictures that follow are of the folding steps that go to the roof. There are 5 steps with a handle at the top right similar if not the same as the ones beneath the windshields.







The fuel pressure regulator has arrived, I need to install it and a higher flow fuel pump to handle heavy throttle positions for more than about 5 seconds. Pics of that after install. I will need to remove the fuel filter on top of the motor, as it boils-off all the fuel in it on shut-down of the engine and is not needed now that there is a big filter before the electric fuel pump.

Two Different Heads

The morning I was to leave for my last camping trip, a discovery was made as he spark plugs were being changed. The spark plugs on the right side of the 440 engine are different than the left. WHAT? Well, so I must have a least one head that did not come with the motor. The right side has plugs with a compression washer, the left has a beveled edge, much like a lug nut. So, the left side did not receive new plugs. This is not horrible news, just an inconvenience. I wonder what year they changed from one to the other?

Camping trip to Devil's Den and fuel pressure findings.

Last Sunday Ben and I went to Devil's Den in the Travco to visit Gigi and Grandpa Shertzer. This was Ben's first overnight camping trip, now 2 years and 10 months old. Ben had a wonderful time and since Mommy was not there to tell Dad to put him to bed, we stayed-up about 90 minutes past his bedtime to see the fireflies and nightfall. I used the generator to run the air conditioning on the way there and back. That night was the first time I used the A/C overnight while camping, normally I dry camp out in the boondocks without any plug-ins. The RV slot was not all in the shade, so for Ben to take a nap, I put a tarp over the back window to try to block more of the light and heat. I think I need to make a custom foil on foam insert for the windows to block light and heat. I suppose I could use the foil bubble wrap stuff, but I like the idea of a firm insert for the back window. I will try both methods and see which I prefer.

I had installed a fuel pressure gauge as I was still having problems sometimes with it running well. What I found was that on heavy acceleration after a few seconds the fuel pressure would start to drop, and at about 4psi, the engine would start to fumble. So, obviously I need a pump with better flow, but to do so I will definitely need a fuel pressure regulator. I have read that the fuel pressure should be between 5-7psi. VoyageVixen, I want to know how the 6-pack works-out when you get it installed. I need help finding a gas cap, as the PO lost the cap for me. I am using a "test-plug, but it doesn't seem to fit tight anymore. Any suggestions? It has a pipe thread, but I think it is less than 2", but more than 1.5"?